Skip to content

Ceres · Zoning · C-1

Ceres C-1 zoning: height, setbacks and lot size

In Ceres's C-1 zone, the front setback is 10 ft, the rear setback limit is 10 ft and the lot coverage limit is 50% (Ceres code, read October 2026).

Key points

  • Minimum front setback: 10 ft
  • Minimum rear setback: 10 ft
  • Maximum lot coverage: 50%
  • Maximum floor area ratio (FAR): 0.50:1.0 (For all single story buildings and the first story of all multiple story buildings)

C-1 (Neighborhood Commercial Zone) is a zoning district in Ceres. Every value below was read from the Ceres Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in C-1

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Minimum front setback
10 ft
§ 18.15.060 · code text
Front yard: Ten feet minimum, except detached accessory structures shall have a 20-foot minimum front yard.
Minimum rear setback
10 ft
§ 18.15.060 · code text
Rear yard: Ten feet minimum.
Maximum lot coverage
50%
§ 18.15.060 · code text
The maximum allowable lot coverage by structures shall be 50 percent.
Maximum floor area ratio (FAR)
0.50:1.0
Applies: For all single story buildings and the first story of all multiple story buildings
§ 18.15.060 · code text
For all single story buildings and the first story of all multiple story buildings, the maximum allowable floor area ratio shall be 0.50:1.0.

When a different number applies

The code sets other values for particular lots, buildings or locations in C-1:

  • Minimum front setback: 20 ft — Detached accessory structures § 18.15.060
  • Minimum side setback: 10 ft — Exterior side yard § 18.15.060
  • Minimum rear setback: Same size as the R-zone property or greater — When property in a C-1 zone is continuous with any yard in an R-zone on the same block frontage § 18.15.060
  • Maximum floor area ratio (FAR): 0.80:1.0 — For all two-story buildings § 18.15.060

Not on this page

We did not find a general height, stories, side setback, lot size, density limit for C-1 in the zoning tables we read. The code may still set one elsewhere — check the Ceres Municipal Code.

Other Ceres zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the minimum front setback in Ceres's C-1 zone?

10 ft — Ceres Municipal Code § 18.15.060.

What is the minimum rear setback in Ceres's C-1 zone?

10 ft — Ceres Municipal Code § 18.15.060.

What is the maximum lot coverage in Ceres's C-1 zone?

50% — Ceres Municipal Code § 18.15.060.

What is the maximum floor area ratio (far) in Ceres's C-1 zone?

0.50:1.0 (for all single story buildings and the first story of all multiple story buildings) — Ceres Municipal Code § 18.15.060.

General information, not legal advice.

Ask about a Ceres property in C-1

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Ceres