Skip to content

Culver City · Zoning · RLD

Culver City RLD zoning: height, setbacks and lot size

In Culver City's RLD zone, buildings can be up to 32 ft tall, the front setback is 10 ft and the minimum lot size is 5,000 square feet (Culver City code, read October 2026).

Key points

  • Maximum building height: 32 ft
  • Minimum front setback: 10 ft
  • Minimum side setback: 5 ft
  • Minimum rear setback: 10 ft
  • Minimum lot size: 5,000 square feet
  • Maximum density: 35 units/acre

RLD is a zoning district in Culver City. Every value below was read from the Culver City Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in RLD

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
32 ft
§ 17.210.020 · code text
Table row “Maximum height - primary building”, column “RLD”: 32 feet
Minimum front setback
10 ft
§ 17.210.020 · code text
Table row “Front - minimum”, column “RLD”: 10 feet
Minimum side setback
5 ft
§ 17.210.020 · code text
Table row “Interior side - minimum”, column “RLD”: 5 feet
Minimum rear setback
10 ft
§ 17.210.020 · code text
Table row “Rear - minimum”, column “RLD”: 10 feet
Minimum lot size
5,000 square feet
§ 17.210.020 · code text
Table row “Minimum lot area”, column “RLD”: 5,000 square feet
Maximum density
35 units/acre
§ 17.210.020 · code text
Table row “Maximum residential density (units/gross acre)”, column “RLD”: 35 units/acre

Uses in RLD

Uses the code's use tables allow in RLD, or allow with a permit. Each links to its page with the code section.

Not on this page

We did not find a general stories, lot coverage, FAR limit for RLD in the zoning tables we read. The code may still set one elsewhere — check the Culver City Municipal Code.

Other Culver City zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Culver City's RLD zone?

32 ft — Culver City Municipal Code § 17.210.020.

What is the minimum front setback in Culver City's RLD zone?

10 ft — Culver City Municipal Code § 17.210.020.

What is the minimum side setback in Culver City's RLD zone?

5 ft — Culver City Municipal Code § 17.210.020.

What is the minimum rear setback in Culver City's RLD zone?

10 ft — Culver City Municipal Code § 17.210.020.

What is the minimum lot size in Culver City's RLD zone?

5,000 square feet — Culver City Municipal Code § 17.210.020.

General information, not legal advice.

Ask about a Culver City property in RLD

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Culver City