Farmersville · Zoning · I
Farmersville I zoning: height, setbacks and lot size
In Farmersville's I zone, generally buildings can be up to no height limitation tall and the front setback is 8 ft, with the conditions listed below (Farmersville code, read October 2026).
Key points
- Maximum building height: no height limitation (within 200 ft of a residential or agricultural zone designated for future residential development, no principal building may exceed 40 ft)
- Minimum front setback: 8 ft
- Minimum side setback: None required (Interior side; the residential zone's rule applies where the lot abuts one)
- Minimum rear setback: None required
I (Industrial Zone) is a zoning district in Farmersville. Every value below was read from the Farmersville Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.
Development standards in I
The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.
| Maximum building height | no height limitation Applies: within 200 ft of a residential or agricultural zone designated for future residential development, no principal building may exceed 40 ft § 17.60.040 · code textThere are no height limitations in an I zone, except that within two hundred feet of any residential or agricultural zone designated for future residential development in the general plan, no principal building shall exceed forty feet in height except as provided in Chapter 17.88. |
|---|---|
| Minimum front setback | 8 ft § 17.60.050 · code textA. Front Yard: Eight feet. |
| Minimum side setback | None required Applies: Interior side; the residential zone's rule applies where the lot abuts one § 17.60.050 · code text1. Interior Side: None, except when abutting a residential zone, then not less than required for said residential zone. |
| Minimum rear setback | None required § 17.60.050 · code textC. Rear Yard: None. |
When a different number applies
The code sets other values for particular lots, buildings or locations in I:
- Maximum building height: 40 ft — Within two hundred feet of a residential zone, or of an agricultural zone planned for future housing § 17.60.040
- Minimum side setback: not less than required for said residential zone — When abutting a residential zone. § 17.60.050
Not on this page
We did not find a general stories, lot size, lot coverage, FAR, density limit for I in the zoning tables we read. The code may still set one elsewhere — check the Farmersville Municipal Code.
Other Farmersville zoning districts
Who this affects
Frequently asked questions
What is the maximum building height in Farmersville's I zone?
no height limitation (within 200 ft of a residential or agricultural zone designated for future residential development, no principal building may exceed 40 ft) — Farmersville Municipal Code § 17.60.040.
What is the minimum front setback in Farmersville's I zone?
8 ft — Farmersville Municipal Code § 17.60.050.
What is the minimum side setback in Farmersville's I zone?
None required (interior side; the residential zone's rule applies where the lot abuts one) — Farmersville Municipal Code § 17.60.050.
What is the minimum rear setback in Farmersville's I zone?
None required — Farmersville Municipal Code § 17.60.050.
General information, not legal advice.
Ask about a Farmersville property in I
Ask GoCodebook what you can build at a specific address and get an answer that cites the section.
Ask your question