Skip to content

Lincoln · Zoning · I

Lincoln I zoning: height, setbacks and lot size

In Lincoln's I zone, buildings can be up to 100 feet tall, the front setback is 25 ft and the minimum lot size is 10,000 sq ft (Lincoln code, read October 2026).

Key points

  • Maximum building height: 100 feet
  • Minimum front setback: 25 ft
  • Minimum side setback: 10 ft
  • Minimum rear setback: 10 ft
  • Minimum lot size: 10,000 sq ft
  • Maximum lot coverage: 75%

I (I Industrial District) is a zoning district in Lincoln. Every value below was read from the Lincoln Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in I

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
100 feet
§ 18.28.030 · code text
The maximum height for buildings and structures in the I district shall be 100 feet.
Minimum front setback
25 ft
§ 18.28.070 · code text
(1) Front Yard. There shall be a front yard of not less than 25 feet in depth.
Minimum side setback
10 ft
§ 18.28.070 · code text
(3) Side Yard. There shall be a side yard on each side of all buildings of not less than ten feet.
Minimum rear setback
10 ft
§ 18.28.070 · code text
(2) Rear Yard. There shall be a rear yard for each lot of not less than ten feet.
Minimum lot size
10,000 sq ft
§ 18.28.040 · code text
(2) Interior lot: 10,000 square feet.
Maximum lot coverage
75%
§ 18.28.050 · code text
The maximum lot coverage by all structures and buildings in the I district shall not exceed 75 percent of the lot area.

Uses in I

Uses the code's use tables allow in I, or allow with a permit. Each links to its page with the code section.

  • Kennel — Allowed — see note

Not on this page

We did not find a general stories, FAR, density limit for I in the zoning tables we read. The code may still set one elsewhere — check the Lincoln Municipal Code.

Other Lincoln zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Lincoln's I zone?

100 feet — Lincoln Municipal Code § 18.28.030.

What is the minimum front setback in Lincoln's I zone?

25 ft — Lincoln Municipal Code § 18.28.070.

What is the minimum side setback in Lincoln's I zone?

10 ft — Lincoln Municipal Code § 18.28.070.

What is the minimum rear setback in Lincoln's I zone?

10 ft — Lincoln Municipal Code § 18.28.070.

What is the minimum lot size in Lincoln's I zone?

10,000 sq ft — Lincoln Municipal Code § 18.28.040.

General information, not legal advice.

Ask about a Lincoln property in I

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Lincoln