Skip to content

San Joaquin County · Zoning · R-R

San Joaquin County R-R zoning: height, setbacks and lot size

In San Joaquin County's R-R zone, generally buildings can be up to 40 ft tall, the front setback is 30 ft and the minimum lot size is 1 acre, with the conditions listed below (San Joaquin County code, read October 2026).

Key points

  • Maximum building height: 40 ft (Dwellings)
  • Minimum front setback: 30 ft (Front and street side yards, regular case; larger figure applies on narrow rights-of-way (see below))
  • Minimum side setback: 15 ft (Main structure)
  • Minimum rear setback: 30 ft (Main structure)
  • Minimum lot size: 1 acre
  • Maximum density: 1.25 units/net area

R-R is a zoning district in San Joaquin County. Every value below was read from the San Joaquin County Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in R-R

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
40 ft
Applies: Dwellings
§ 9-200.030 · code text
Table row “Dwellings”, column “R-R”: 40
Minimum front setback
30 ft
Applies: Front and street side yards, regular case; larger figure applies on narrow rights-of-way (see below)
§ 9-200.030 · code text
Table row “Front & Street Side—Regular; Right-of-Way less than 50′”, column “R-R”: 30; 55 3
Minimum side setback
15 ft
Applies: Main structure
§ 9-200.030 · code text
Table row “Interior Side - Main Structure; Accessory Structures”, column “R-R”: 15; 10
Minimum rear setback
30 ft
Applies: Main structure
§ 9-200.030 · code text
Table row “Rear - Main Structure; Accessory Structures; Reverse Corner Lots”, column “R-R”: 30; 15; 15
Minimum lot size
1 acre
§ 9-200.030 · code text
Table row “Minimum Lot Size (sq. ft.)”, column “R-R”: 1 acre
Maximum density
1.25 units/net area
§ 9-200.030 · code text
Table row “Maximum Density (units/net area)”, column “R-R”: 1.25

Uses in R-R

Uses the code's use tables allow in R-R, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in R-R:

  • Minimum front setback: 55 ft — Where the right-of-way is less than 50 ft; measured from the road centerline § 9-200.030

Not on this page

We did not find a general stories, lot coverage, FAR limit for R-R in the zoning tables we read. The code may still set one elsewhere — check the San Joaquin County Municipal Code.

Other San Joaquin County zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in San Joaquin County's R-R zone?

40 ft (dwellings) — San Joaquin County Municipal Code § 9-200.030.

What is the minimum front setback in San Joaquin County's R-R zone?

30 ft (front and street side yards, regular case; larger figure applies on narrow rights-of-way (see below)) — San Joaquin County Municipal Code § 9-200.030.

What is the minimum side setback in San Joaquin County's R-R zone?

15 ft (main structure) — San Joaquin County Municipal Code § 9-200.030.

What is the minimum rear setback in San Joaquin County's R-R zone?

30 ft (main structure) — San Joaquin County Municipal Code § 9-200.030.

What is the minimum lot size in San Joaquin County's R-R zone?

1 acre — San Joaquin County Municipal Code § 9-200.030.

General information, not legal advice.

Ask about a San Joaquin County property in R-R

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on San Joaquin County