Skip to content

Taft · Zoning · MU

Taft MU zoning: height, setbacks and lot size

In Taft's MU zone, buildings can be up to 45 ft tall, the front setback is 0 ft and the minimum lot size is 12,500 sq ft (Taft code, read October 2026).

Key points

  • Maximum building height: 45 ft
  • Minimum front setback: 0 ft
  • Minimum rear setback: 0 ft
  • Minimum lot size: 12,500 sq ft
  • Maximum floor area ratio (FAR): 0.85
  • Maximum density: 29 units per acre (multi-family and mixed-use residential developments; state law (AB 2011, SB 6) may change it)

MU (Mixed Use) is a zoning district in Taft. Every value below was read from the Taft Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in MU

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
45 ft
§ 6-5-4 · code text
Table row “Building height, in feet, maximum (may be exceeded with an approved conditional use permit)”, column “MU”: 45
Minimum front setback
0 ft
§ 6-5-4 · code text
Table row “Front building setback, in feet”, column “MU”: 0
Minimum rear setback
0 ft
§ 6-5-4 · code text
Table row “Rear setback”, column “MU”: 0
Minimum lot size
12,500 sq ft
§ 6-5-4 · code text
Table row “Minimum site area (square feet, net)”, column “MU”: 12,500 1
Maximum floor area ratio (FAR)
0.85
§ 6-5-4 · code text
Table row “Maximum floor area ratio”, column “MU”: 0.85
Maximum density
29 units per acre
Applies: multi-family and mixed-use residential developments; state law (AB 2011, SB 6) may change it
§ 6-5-4 · code text
Multi-family residential and mixed-use residential developments in the MU and DC Zone Districts are allowed a maximum residential density of twenty-nine dwelling units per acre (29 du/ac) consistent with the mixed use land use designation of the General Plan, except as modified by applicable state law including Assembly Bill 2011 (AB 2011) and Senate Bill 6 (SB 6), as codified in Government Code Sections 65912.100 et seq. and 65852.24 et seq.

Uses in MU

Uses the code's use tables allow in MU, or allow with a permit. Each links to its page with the code section.

Not on this page

We did not find a general stories, side setback, lot coverage limit for MU in the zoning tables we read. The code may still set one elsewhere — check the Taft Municipal Code.

Other Taft zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Taft's MU zone?

45 ft — Taft Municipal Code § 6-5-4.

What is the minimum front setback in Taft's MU zone?

0 ft — Taft Municipal Code § 6-5-4.

What is the minimum rear setback in Taft's MU zone?

0 ft — Taft Municipal Code § 6-5-4.

What is the minimum lot size in Taft's MU zone?

12,500 sq ft — Taft Municipal Code § 6-5-4.

What is the maximum floor area ratio (far) in Taft's MU zone?

0.85 — Taft Municipal Code § 6-5-4.

General information, not legal advice.

Ask about a Taft property in MU

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Taft