Skip to content

Windsor · Zoning · CC

Windsor CC zoning: height, setbacks and lot size

In Windsor's CC zone, generally buildings can be up to 45 ft tall, the front setback is 0 to 10 ft and the minimum lot size is 2,000 sq ft, with the conditions listed below (Windsor code, read October 2026).

Key points

  • Maximum building height: 45 ft
  • Minimum front setback: 0 to 10 ft (the code sets a range: at least 0, at most 10)
  • Minimum side setback: None required (Adjacent to nonresidential)
  • Minimum rear setback: None required (Adjacent to nonresidential)
  • Minimum lot size: 2,000 sq ft
  • Maximum floor area ratio (FAR): 0.8 without residential or 1.5 with residential (without residential or with residential)
  • Maximum density: 16 du/ac

CC is a zoning district in Windsor. Every value below was read from the Windsor Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in CC

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
45 ft
§ 17.12.050 · code text
Table row “Maximum (ft.)”, column “CC”: 45
Minimum front setback
0 to 10 ft
Applies: the code sets a range: at least 0, at most 10
§ 17.12.050 · code text
Table row “Minimum”, column “CC”: 0—10
Minimum side setback
None required
Applies: Adjacent to nonresidential
§ 17.12.050 · code text
Table row “Adjacent to Nonresidential”, column “CC”: None required
Minimum rear setback
None required
Applies: Adjacent to nonresidential
§ 17.12.050 · code text
Table row “Adjacent to Nonresidential”, column “CC”: None required
Minimum lot size
2,000 sq ft
§ 17.12.050 · code text
Table row “Area (sq. ft.)”, column “CC”: 2,000
Maximum floor area ratio (FAR)
0.8 without residential or 1.5 with residential
Applies: without residential or with residential
§ 17.12.050 · code text
Table row “Maximum”, column “CC”: 0.8 without residential or 1.5 with residential
Maximum density
16 du/ac
§ 17.12.050 · code text
Table row “Maximum”, column “CC”: 16

Uses in CC

Uses the code's use tables allow in CC, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in CC:

  • Minimum side setback: 5 ft — Adjacent to Residential § 17.12.050
  • Minimum side setback: 10 ft — Street Side § 17.12.050
  • Minimum rear setback: 5 ft — Adjacent to Residential § 17.12.050

Not on this page

We did not find a general stories, lot coverage limit for CC in the zoning tables we read. The code may still set one elsewhere — check the Windsor Municipal Code.

Other Windsor zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Windsor's CC zone?

45 ft — Windsor Municipal Code § 17.12.050.

What is the minimum front setback in Windsor's CC zone?

0 to 10 ft (the code sets a range: at least 0, at most 10) — Windsor Municipal Code § 17.12.050.

What is the minimum side setback in Windsor's CC zone?

None required (adjacent to nonresidential) — Windsor Municipal Code § 17.12.050.

What is the minimum rear setback in Windsor's CC zone?

None required (adjacent to nonresidential) — Windsor Municipal Code § 17.12.050.

What is the minimum lot size in Windsor's CC zone?

2,000 sq ft — Windsor Municipal Code § 17.12.050.

General information, not legal advice.

Ask about a Windsor property in CC

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Windsor