Skip to content

Yuba County · Zoning · RH

Yuba County RH zoning: height, setbacks and lot size

In Yuba County's RH zone, generally buildings can be up to 50 ft tall, the front setback is 10 ft from edge of sidewalk and the minimum lot size is 10,000 sq ft, with the conditions listed below (Yuba County code, read October 2026).

Key points

  • Maximum building height: 50 ft
  • Minimum front setback: 10 ft from edge of sidewalk (detached sidewalk)
  • Minimum side setback: 5 ft
  • Minimum rear setback: 10 ft
  • Minimum lot size: 10,000 sq ft
  • Maximum density: 30 units per acre

RH is a zoning district in Yuba County. Every value below was read from the Yuba County Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in RH

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
50 ft
§ 11.07.030 · code text
Table row “Primary structure”, column “RH”: 50(C)
Minimum front setback
10 ft from edge of sidewalk
Applies: detached sidewalk
§ 11.07.030 · code text
Table row “Front or street side”, column “RH”: Detached sidewalk: Ten ft. from edge of sidewalk Attached sidewalk: 15 ft. from edge of sidewalk No sidewalk: 15 ft. from edge of ultimate right-of-way and ten feet from edge of drainage ditch if present
Minimum side setback
5 ft
§ 11.07.030 · code text
Table row “Interior side”, column “RH”: 5 (D)
Minimum rear setback
10 ft
§ 11.07.030 · code text
Table row “Rear, primary structure”, column “RH”: 10
Minimum lot size
10,000 sq ft
§ 11.07.030 · code text
Table row “Minimum lot area (square feet)”, column “RH”: 10,000
Maximum density
30 units per acre
§ 11.07.030 · code text
Table row “Maximum”, column “RH”: 30

Uses in RH

Uses the code's use tables allow in RH, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in RH:

  • Maximum building height: 30 ft — within 40 feet of an RS District § 11.07.030
  • Maximum building height: 40 ft — within 50 feet of an RS District § 11.07.030
  • Minimum front setback: 15 ft from edge of sidewalk — attached sidewalk § 11.07.030
  • Minimum front setback: 15 ft from edge of ultimate right-of-way — no sidewalk; and 10 ft from edge of drainage ditch if present § 11.07.030

Not on this page

We did not find a general stories, lot coverage, FAR limit for RH in the zoning tables we read. The code may still set one elsewhere — check the Yuba County Municipal Code.

Other Yuba County zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Yuba County's RH zone?

50 ft — Yuba County Municipal Code § 11.07.030.

What is the minimum front setback in Yuba County's RH zone?

10 ft from edge of sidewalk (detached sidewalk) — Yuba County Municipal Code § 11.07.030.

What is the minimum side setback in Yuba County's RH zone?

5 ft — Yuba County Municipal Code § 11.07.030.

What is the minimum rear setback in Yuba County's RH zone?

10 ft — Yuba County Municipal Code § 11.07.030.

What is the minimum lot size in Yuba County's RH zone?

10,000 sq ft — Yuba County Municipal Code § 11.07.030.

General information, not legal advice.

Ask about a Yuba County property in RH

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Yuba County