Glendale · Zoning · TOD II
Glendale TOD II zoning: height, setbacks and lot size
In Glendale's TOD II zone, generally buildings can be up to 200 ft tall, the front setback is 12 or 15 ft and the minimum lot size is 10,000 sq ft, with the conditions listed below (Glendale code, read October 2026).
Key points
- Maximum building height: 200 ft
- Minimum front setback: 12 or 15 ft (Public realm minimum setback; the table gives 12 or 15 ft and refers to the TOD site planning section)
- Minimum side setback: None required
- Minimum lot size: 10,000 sq ft (For new parcels)
- Maximum density: 100 dwelling units per acre
TOD II is a zoning district in Glendale. Every value below was read from the Glendale Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.
Development standards in TOD II
The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.
| Maximum building height | 200 ft See notes 1, 2, 3 below the table in the code. § 30.16.030 · code textTable row “Maximum Height Limits (1), (2), (3) Buildings and Structures”, column “TOD II”: 200 feet Note 1: Enclosed or screened rooftop equipment not exceeding five feet in height above the roof of a building shall not be computed as part of the height of the building. Elevator shafts and rooftop stairwells not exceeding 15 feet in height above the roof of a building shall not be computed as part of the height of the building. See Chapter 30.70 (Definitions). Note 2: For exceptions to height limits for wireless telecommunications facilities, see Chapter 30.48 (Wireless Telecommunications Facilities Permits). Note 3: For setback and height requirements related to solar energy equipment, see Section 30.30.050 (Solar Energy Equipment). |
|---|---|
| Minimum front setback | 12 or 15 ft Applies: Public realm minimum setback; the table gives 12 or 15 ft and refers to the TOD site planning section § 30.16.030 · code textTable row “Street Front and Street Side”, column “TOD II”: Public realm minimum setback of 12 or 15 feet, see Section 30.16.050 (TOD District Site Planning) |
| Minimum side setback | None required § 30.16.030 · code textTable row “Interior”, column “TOD II”: None |
| Minimum lot size | 10,000 sq ft Applies: For new parcels § 30.16.030 · code textTable row “Area”, column “TOD II”: 10,000 square feet |
| Maximum density | 100 dwelling units per acre § 30.16.030 · code textTable row “Maximum Residential Density”, column “TOD II”: 100 dwelling units per acre |
Uses in TOD II
Uses the code's use tables allow in TOD II, or allow with a permit. Each links to its page with the code section.
- Child care center — Needs an administrative use permit
Not on this page
We did not find a general stories, rear setback, lot coverage, FAR limit for TOD II in the zoning tables we read. The code may still set one elsewhere — check the Glendale Municipal Code.
Other Glendale zoning districts
Who this affects
Frequently asked questions
What is the maximum building height in Glendale's TOD II zone?
200 ft — Glendale Municipal Code § 30.16.030.
What is the minimum front setback in Glendale's TOD II zone?
12 or 15 ft (public realm minimum setback; the table gives 12 or 15 ft and refers to the TOD site planning section) — Glendale Municipal Code § 30.16.030.
What is the minimum side setback in Glendale's TOD II zone?
None required — Glendale Municipal Code § 30.16.030.
What is the minimum lot size in Glendale's TOD II zone?
10,000 sq ft (for new parcels) — Glendale Municipal Code § 30.16.030.
What is the maximum density in Glendale's TOD II zone?
100 dwelling units per acre — Glendale Municipal Code § 30.16.030.
General information, not legal advice.
Ask about a Glendale property in TOD II
Ask GoCodebook what you can build at a specific address and get an answer that cites the section.
Ask your question