Skip to content

Tehama County · Zoning · R-3

Tehama County R-3 zoning: height, setbacks and lot size

In Tehama County's R-3 zone, buildings can be up to 35 ft tall and the front setback is 50 ft from roadway centerline or 20 ft from property line, whichever is greater (Tehama County code, read October 2026).

Key points

  • Maximum building height: 35 ft
  • Minimum front setback: 50 ft from roadway centerline or 20 ft from property line, whichever is greater
  • Minimum side setback: 20% of lot width in total, with no side yard less than 6 ft (add 3 ft per story above the first; street side of corner lots at least 10 ft)
  • Minimum rear setback: 20 ft
  • Maximum lot coverage: 50%

R-3 (Neighborhood Apartment District) is a zoning district in Tehama County. Every value below was read from the Tehama County Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in R-3

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
35 ft
§ 17.20.080 · code text
A. Building height limit, two and one-half stories, but not to exceed thirty-five feet;
Minimum front setback
50 ft from roadway centerline or 20 ft from property line, whichever is greater
§ 17.20.050 · code text
A. Front yard, fifty feet from the centerline of roadway or twenty feet from the property line, whichever is greater;
Minimum side setback
20% of lot width in total, with no side yard less than 6 ft
Applies: add 3 ft per story above the first; street side of corner lots at least 10 ft
§ 17.20.050 · code text
B. Side Yards. Side yards shall total not less than twenty percent of the lot width, and no side yard may be less than six feet; three feet shall be added to each required side yard for each story above the first story of any building; the side yard on the street side of each corner lot shall be not less than ten feet;
Minimum rear setback
20 ft
§ 17.20.050 · code text
C. Rear yards, twenty feet.
Maximum lot coverage
50%
§ 17.20.080 · code text
B. Maximum building coverage, fifty percent of lot area.

When a different number applies

The code sets other values for particular lots, buildings or locations in R-3:

  • Minimum side setback: Add 3 ft to each required side yard for each story above the first story — For each story above the first story of any building § 17.20.050
  • Minimum side setback: 10 ft — Street side of a corner lot § 17.20.050

Not on this page

We did not find a general stories, lot size, FAR, density limit for R-3 in the zoning tables we read. The code may still set one elsewhere — check the Tehama County Municipal Code.

Other Tehama County zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Tehama County's R-3 zone?

35 ft — Tehama County Municipal Code § 17.20.080.

What is the minimum front setback in Tehama County's R-3 zone?

50 ft from roadway centerline or 20 ft from property line, whichever is greater — Tehama County Municipal Code § 17.20.050.

What is the minimum side setback in Tehama County's R-3 zone?

20% of lot width in total, with no side yard less than 6 ft (add 3 ft per story above the first; street side of corner lots at least 10 ft) — Tehama County Municipal Code § 17.20.050.

What is the minimum rear setback in Tehama County's R-3 zone?

20 ft — Tehama County Municipal Code § 17.20.050.

What is the maximum lot coverage in Tehama County's R-3 zone?

50% — Tehama County Municipal Code § 17.20.080.

General information, not legal advice.

Ask about a Tehama County property in R-3

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Tehama County