107.2 Limitations of Authority — 2025 California Plumbing Code

The Board of Appeals shall have no authority relative to interpretation of the administrative provisions of this code, nor shall the board be empowered to waive requirements of this code.

TABLE 104.5

PLUMBING PERMIT FEES

Permit Issuance

1. For issuing each permit ............................................................................................................................................*______

2. For issuing each supplemental permit......................................................................................................................*______

Unit Fee Schedule (in addition to Item 1 and Item 2 above)

1. For each plumbing fixture on one trap or a set of fixtures on one trap (including water, drainage piping, and backflow protection therefore) ...............................................................................................*______

2. For each building sewer and each trailer park sewer ...............................................................................................*______

3. Rainwater systems – per drain (inside building)......................................................................................................*______

4. For each cesspool (where permitted) .......................................................................................................................*______

5. For each private sewage disposal system.................................................................................................................*______

6. For each water heater, vent, or both.........................................................................................................................*______

7. For each gas piping system of one to five outlets ....................................................................................................*______

8. For each additional gas piping system outlet, per outlet..........................................................................................*______

9. For each industrial waste pretreatment interceptor, including its trap and vent, except kitchen-type grease interceptors functioning as fixture traps.......................................................................*______

10. For each installation, alteration, or repair of water piping, water treating equipment, or both ...............................*______

11. For each repair or alteration of drainage or vent piping, each fixture......................................................................*______

12. For each lawn sprinkler system on one meter including backflow protection devices therefore ............................*______

13. For atmospheric-type vacuum breakers not referenced in Item 12:

One to 5.............................................................................................................................................................*______

Over 5, each ......................................................................................................................................................*______

14. For each backflow protective device other than atmospheric-type vacuum breakers:

Two inches (50 mm) in diameter and smaller ..................................................................................................*______

Over 2 inches (50 mm) in diameter ..................................................................................................................*______

15. For each gray water system......................................................................................................................................*______

16. For initial installation and testing of a reclaimed water system...............................................................................*______

17. For each annual cross-connection testing of a reclaimed water system (excluding initial test) ..............................*______

18. For each medical gas piping system serving one to five inlet(s)/outlet(s) for a specific gas...................................*______

19. For each additional medical gas inlet(s)/outlet(s) ....................................................................................................*______

Other Inspections and Fees

1. Inspections outside of normal business hours..........................................................................................................*______

2. Reinspection fee.......................................................................................................................................................*______

3. Inspections for which no fee is specifically indicated..............................................................................................*______

4. Additional plan review required by changes, additions, or revisions to approved plans (minimum charge – 1/2 hour)........................................................................................*______

For SI units: 1 inch = 25 mm

• Jurisdiction will indicate their fees here